MF1700-A1

Full-auto Hot and Cold laminator MF1700-A1 represent the highest industrial product by Impress for a high-end market. It has been the most human and efficient laminating machine ever. A laminating and mounting width up to 1620mm(64”), ensures most application possibilities.

MF1700-A1 is for extremely demanding finishing requirements. This wide-format and heavy-duty laminator is designed for the widest choice of finishing possibilities. Precise air pressure and nip control offer a better and easy operation experience. Standardized emergency buttons and laser eye ensures the operator works in complete safety.

Before first use of the Impress laminator, you should carefully read this manual, which contains important instructions, indications, and safety information. Failure to read the manual may result in serious injury to operators and damage to machine

To know clearly about this manual for using safely with flatbeds, you need to be familiar with the warning symbols in this manual.

In order to make a full understanding of the machine, please read this manual carefully before opera on. Take care when operating the machine, especially if more than one operator is using it.

The power supply should meet the requirement of the machine.

The emergency stop function and the mechanical stop function for the machine should be testing connected on with the installation, servicing, maintenance, etc.

In order to make a full understanding of the machine, please read this manual carefully before operation

Do not use water to clean the machine in case of a short circuit, electric shock, or rust. In order not to hurt the rollers, please do not put any hard stuff on the machine. Check the chains and gears at a regular me, clean and lubricate

In the event of an emergency, press the emergency stop bu on to stop the laminator in an emergency. Then the machine will run again and the bu on will bounce up when you clockwise rotate to the neutral position.

Red emergency stop bu ones are located at the two sides of the machine.

The Impress Laminator should be assembled and used in a clean room with a normal room temperature and normal humidity levels. The workplace should be dry and ventilated. Do not use this machine near a water source or wet ground. This minimizes the occurrence of sta c electricity. In the meanwhile, do not be close to combustible and explosive goods.

When the machine is delivered, the following units are included

• Impress laminator
• Manual
• Accessories

Voltage: AC220/240V 50-60HZ

Electrical connectors may only be connected to
socked sockets with the correct voltage. All
other operations may only be performed by
authorized staff.

The Impress Laminator should be placed in a dry and ventilated situation.

Check the chains and gears (at a regular me), clean, and lubricate.

The roller is hot during working, please do not touch it,in case of scalded or bruised.

Place the roller in the idle position, raised 5 mm above the working table.
Clean the roller on a regular me, do not use water to clean the machine in case of a short circuit, electric shock, or rust. Use 80% alcohol, detergent, or eraser to clean the rollers alter lamina on, which can
lengthen the rollers’ life.
1. The temperature of the roller should be under 40℃ and stop heating.
2. Do not focus on one point.
3. Clean the residuum in me, otherwise, it will affect the yields.

Assembly with the steps performed by a technician
authorized.